The following is a guide that covers how to install your PetroSaver System on your engine.
Pre-Installation Test (optional)
Try this test before you install the Petrosaver.
Fill gas tank with gasoline
Set timer (to see how long equipment will run on a full tank)
Run equipment until it runs out of gas
Stop timer and record time
Before installing on your Lawn Mower or small power equipment. MAKE SURE THE ENGINE IS COOL!
The first step is to Locate all items that is needed to install the PetroSaver System. Here is a quick explanation of each of the item needed.
The Petrosaver system (included in package)
Spark plug wire
Household Pliers
Step 1 -
Install the Petosaver on the spark plug wire, by wrappping it around the wire and inserting the zip-tie into the slots.
Step 2 -
Squeeze together until tight with house hold pliers until the Petrosaver system is tight.
That's it your finished. It should take less than 20 seconds. (in some cases a cover may need to be removed and replaced to access the spark plug wire)
You will know immediately from the sound and smell that the Petrosaver is working.
Post-Installation Test
Try this test after you install the Petrosaver.
Fill gas tank with gasoline
Set timer (to see how long equipment will run on a full tank)
Run equipment until it runs out of gas (put the power equipment to work)
Stop timer and record time
Notice the Difference!
(1) You will have less EMISSION.
(2) You will have a LONGER RUN time 10-60 minute on a tank of gas.
(3) You will have more POWER and TORQUE.
The way it Works:
The Petrosaver has a patent pending proprietary resin that gives a greater fire before the burn, and captures and holds the power thats being lost without the Petrosaver being installed.
